Seafoam Revive Oil-to-Foam Cleanser

Ocean Journal  /  11 September 2026

The SPF Reset: How to Remove Waterproof Sunscreen After a Water Day

A practical post-water face-cleansing guide: loosen waterproof SPF, zinc, salt, sweat, makeup and daily buildup on dry skin, add water to activate a soft foam, then rinse thoroughly.

Waterproof sunscreen and zinc earn their place on a water day. The part that matters afterwards is taking them off without turning your evening cleanse into a battle.

A good post-water face cleanse starts before the foam. Use an oil-to-foam formula on dry skin to loosen sunscreen, salt, sweat, makeup and daily buildup, then add water and rinse. One product, two cleansing phases, a clean and comfortable finish.

01

Begin Before the Foam

Start with dry hands and a dry face. Massage Seafoam Revive Oil-to-Foam Cleanser across the skin so its silky oil texture can loosen waterproof SPF, zinc, salt, sweat, makeup and daily buildup. Give extra attention to the places sunscreen tends to be applied most carefully: around the hairline, beside the nose and along the jaw.

Seafoam Revive silky oil texture dispensed into a hand before adding water
02

Add Water to Change the Cleanse

Wet your fingertips and continue massaging as the formula turns into a soft, creamy foam. That shift is what makes Seafoam Revive a double cleanse in one: the first phase loosens buildup, the second lifts it away.

03

Rinse Thoroughly, Without the Stripped Feeling

Rinse with fresh water until the foam is gone, then pat the skin dry. Seafoam Revive purifies without stripping and helps preserve the skin's moisture balance, leaving the face feeling fresh, balanced and comfortable rather than tight.

04

Make the Reset Match the Day

For a deeper cleanse, massage two to three pumps onto dry skin before adding water. No sunscreen today? Begin with damp skin and lather the formula in your palms first for a lighter, single-phase cleanse. Both routes end the same way: rinse thoroughly, then continue with the leave-on care your skin needs. That's the reset.